Hardened stainless steel neck bushing from L.E. Wilson. Wilson makes their bushings in .001” increments. The size marked on them refers to the middle of the bushing, which is reamed with a .003” taper. Since the case neck only reaches the middle, a slightly tighter sizing can be achieved by turning the bushing over, with the markings facing toward the case (markings facing down). This is mainly an emergency step to be taken if the brass has hardened, springing back more, and will no longer hold the bullet; or for fine-tuning the sizing to provide less additional “squeeze” than using the next smaller bushing in the normal way. Made to similar specs to the Redding neck bushings. Will not interchange with Forster or RCBS dies. Brownells Gun Tech™ Tip: There are two ways to select the steel neck bushings you need: (1) Measure the outside neck diameter of your loaded cartridge and subtract .002" to .003". This allows approximately .001" of brass to spring back for correct neck tension. (2) You can also measure the neck wall thickness of your case, multiply by two, add the diameter of your bullet and subtract .002" to .003".
Härdat rostfritt stål nackbussning från L.E. Wilson. Wilson tillverkar sina bussningar i .001” intervall. Storleken som är markerad på dem avser mitten av bussningen, som är urfräst med en .003” kon. Eftersom hylsnackdelen endast når mitten, kan en något tightare sizing uppnås genom att vända bussningen med markeringarna vända mot hylsan (markeringarna vända nedåt). Detta är främst ett nödsteg som bör vidtas om mässingen har härdat, fjädrar tillbaka mer och inte längre håller kulan; eller för att finjustera storleken för att ge mindre ytterligare “kläm” än att använda nästa mindre bussning på det vanliga sättet. Tillverkad med liknande specifikationer som Redding nackbussningar. Kommer inte att passa med Forster eller RCBS dies. Brownells Gun Tech™ Tips: Det finns två sätt att välja de stål nackbussningar du behöver: (1) Mät den yttre nackdiametern på din laddade patron och subtrahera .002" till .003". Detta möjliggör cirka .001" av mässingen att fjädras tillbaka för korrekt nackspänning. (2) Du kan också mäta nackväggens tjocklek på din hylsa, multiplicera med två, lägga till diametern på din kula och subtrahera .002" till .003".