These tools are designed to ream flash holes to specific diameters rather than debur. The handloader addresses three issues when using this tool. 1) It enlarges the holes just enough for the die maker's decapping pins to go through without getting stuck. 2) It removes any burrs left in the flash hole during manufacturing. 3) Each flash hole will be exactly the same size ensuring uniform ignition. This three-piece tools have a stainless steel guide that centers the reamer in the primer pocket, a knurled stainless steel handle and either a .0625” or .081” reamer for small or standard flash holes.
Dessa verktyg är utformade för att reama flashhål till specifika diametrar istället för att avgrada. Handladdaren hanterar tre frågor när denne använder detta verktyg. 1) Det förstorar hålen precis tillräckligt så att avskjutningspinnarna från stämpeltillverkaren kan gå igenom utan att fastna. 2) Det tar bort eventuella grader som lämnas i flashhålet under tillverkningen. 3) Varje flashhål kommer att vara exakt samma storlek vilket säkerställer en enhetlig antändning. Dessa tre-delade verktyg har en guide i rostfritt stål som centrerar reamern i tändhålan, ett räfflat handtag i rostfritt stål och antingen en .0625” eller .081” reamer för små eller standard flashhål.