Trims The Rivet Tip To Make Broken Ejector Spring Removal Simple
Hollow-end mill fits in drill press, spot faces the front rivet to take off just the peened area. Often lets you re-peen the existing rivet and eliminate rebluing the receiver.
Trimmar nitspetsen för att enkelt kunna ta bort trasig utkastarfjäder
Hålförande fräs passar i pelarborr, planar ytan på den främre niten för att bara ta bort det nitade området. Gör det ofta möjligt att åter-nita den befintliga niten och undvika att behöva blånera om mottagaren.
Kundernas betyg påBROWNELLS REMINGTON 870 EJECTOR SPRING RIVET CUTTER
Antal betyg: 1
Från brownells.com: 1
Medelbetyg: 5
Great investment!(2016-02-10)
This little rivet cutter made me save over $200 in gunsmithing work on my old 870 Wingmaster, which had been sitting in the gun safe for years because of a ''too-expensive-to-replace'' broken ejector spring. The instructions provided with the tool are very clear and allowed me, as indicated, to re-use the rivet to lock the new spring into the ejector. The only thing I did differently than prescribed by the instructions was to drive the rivet cutter down on the tiny rivet head by hand instead of using a press drill. The rivet cutter being very sharp and the rivet metal being very soft, I was afraid to ruin the rivet using a press drill. It took me 10 minutes to cut the rivet head slowly and safely by hand (clockwise twist of the fingers with little pressure).
Produktnr: 080000040 BROWNELLS REMINGTON 870 EJECTOR SPRING RIVET CUTTER050806103825 Hålförande fräs passar i pelarborr, planar ytan på den främre niten för att bara ta bort det nitade området. Gör det ofta möjligt att åter-nita den befintliga niten och undvika att behöva blånera om mottagaren.
649SEK0649,00 kr
*
Restorder. Skickas när den finns i lager. Leveranstid ca 4-12 veckor från centrallagret.
Trims The Rivet Tip To Make Broken Ejector Spring Removal Simple
Hollow-end mill fits in drill press, spot faces the front rivet to take off just the peened area. Often lets you re-peen the existing rivet and eliminate rebluing the receiver.
Trimmar nitspetsen för att enkelt kunna ta bort trasig utkastarfjäder
Hålförande fräs passar i pelarborr, planar ytan på den främre niten för att bara ta bort det nitade området. Gör det ofta möjligt att åter-nita den befintliga niten och undvika att behöva blånera om mottagaren.
Kundernas betyg påBROWNELLS REMINGTON 870 EJECTOR SPRING RIVET CUTTER
Antal betyg: 1
Från brownells.com: 1
Medelbetyg: 5
Great investment!(2016-02-10)
This little rivet cutter made me save over $200 in gunsmithing work on my old 870 Wingmaster, which had been sitting in the gun safe for years because of a ''too-expensive-to-replace'' broken ejector spring. The instructions provided with the tool are very clear and allowed me, as indicated, to re-use the rivet to lock the new spring into the ejector. The only thing I did differently than prescribed by the instructions was to drive the rivet cutter down on the tiny rivet head by hand instead of using a press drill. The rivet cutter being very sharp and the rivet metal being very soft, I was afraid to ruin the rivet using a press drill. It took me 10 minutes to cut the rivet head slowly and safely by hand (clockwise twist of the fingers with little pressure).