Simply remove the rear sight on your gun and replace it with EGW mount in order to mount your Leupold DeltaPoint Pro, JPoint, Redfield Accelerator, or Optima red-dot sight. You can take the mount off and replace your rear sight at any time. Mounting hardware included. Installation Instructions Remove the rear sight* Install the EGW Sight Mount in the dovetail Tighten set screw (if applicable) Place the red dot sight on the EGW Sight Mount (placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.) Apply blue Loctite to the provided mounting screws Torque mounting screws to 15in/lbs This mount does not fit: FN FNP (the slide radius is too large to allow this mount to fit) FN 5.7 Any Optics Ready Pistol
Ta bara bort bakre sikten pÄ ditt vapen och ersÀtt det med EGW-monteringen för att montera ditt Leupold DeltaPoint Pro, JPoint, Redfield Accelerator eller Optima rödpunktsikte. Du kan nÀr som helst ta bort monteringen och Ätermontera ditt bakre sikte. Monteringstillbehör ingÄr. Installationsinstruktioner Ta bort bakre sikten* Installera EGW Sight Mount i svansen Dra Ät stÀllskruven (om tillÀmplig) Placera rödpunktsiktet pÄ EGW Sight Mount (att placera en liten bit papper mellan rödpunktsiktet och siktesmonteringen kommer att underlÀtta borttagning och hÄlla Loctite borta frÄn rödpunktsiktet.) Applicera blÄ Loctite pÄ de medföljande monteringsskruvarna Dra Ät monteringsskruvarna till 15in/lbs Denna montering passar inte: FN FNP (slidens radie Àr för stor för att denna montering ska passa) FN 5.7 NÄgon Optics Ready Pistol