FHD FLASH HIDERS These fit the plan B type mounts. This is an updated version that has larger wrench flats on the rear. Always use an alignment rod to ensure that the entire system is set up correctly. Make sure all surfaces are cleaned and the muzzle device has been torqued and Rockset to the barrel. Use on a Q can voids your warranty, be warned. Torque the muzzle device to approximately 30 ft lbs. Make sure the muzzle device is square against the shoulder. When setting the silencer on the muzzle device, ensure that the threads and tapers are clean. Torque the suppressor to 10 ft lbs. Ensure alignment. Enjoy. The nitride finish does lead to a tighter seal, with that said, it is extremely important to torque and rockset your muzzle device to the barrel properly. FEATURES: 17-4 PH H900 Atlas and Atlas XL Compatible Plan B Compatible Atlas XL Adapter No Overrun Black Nitride Finish (67 HRC Surface Hardness) Shims Not Included, if you would like to specifically time this, shims will be required. Note: your barrel may require a shim if the manufacturer did not put a thread relief on it.
FHD FLASH HIDERS Dessa passar för Plan B-typens fästen. Detta är en uppdaterad version som har större skruvytor på baksidan. Använd alltid en justeringsstång för att säkerställa att hela systemet är korrekt inställt. Se till att alla ytor är rengjorda och att muzzle-enheten har dragits åt och Rockset:ats till pipan. Användning på en Q-kan voidar din garanti, var medveten om detta. Dra åt muzzle-enheten till cirka 30 ft lbs. Se till att muzzle-enheten är vinkelrät mot axeln. När du sätter ljuddämparen på muzzle-enheten, se till att gängorna och konerna är rena. Dra åt dämparen till 10 ft lbs. Säkerställ justering. Nitridfinishen ger en tätare försegling, med det sagt är det extremt viktigt att dra åt och Rockset:a din muzzle-enhet till pipan korrekt. EGENSKAPER: 17-4 PH H900 Atlas och Atlas XL-kompatibel Plan B-kompatibel Atlas XL-adapter Ingen överdragning Svart nitridfinish (67 HRC ythårdhet) Shimar ingår inte, om du vill tidsinställa detta specifikt, behövs shimar. Obs: din pipa kan kräva en shim om tillverkaren inte har lagt en gängfrisättning på den.