Varukorgen är tom.

Varukorg

Hjälp och kontakt

Fri frakt på beställningar över 2.999 kr

100 dagars returrätt

Nyhetsbrev

REA

Över 300 000 kunder - vi säger tack!

4,93/5 "Mycket bra" (1400+ recensioner)

40 000+ produkter inom jakt och skytte

SCHUSTER
MA ADJUSTABLE GAS SYSTEM

100001733

Saves Wear On Bolt Lugs & Softens Blow On Op Rod

Vented steel design changes cycle time by letting you adjust the gas volume in the cylinder. Quick adjustment of vent size with integral set-screw; eliminates changing screws for different vent sizes. Reduces battering on op rod, bolt lugs, receiver and trigger group. Available for M1 Garand and M1A.

SPECS: Steel, parkerized finish. Replaces existing gas nut with no modifications to the rifle. Includes adjustment tool and instructions.

Mer...

Sparar på slitage av bultlåsningar & dämpar slaget på op-stången

Ventilerad ståldesign förändrar cykeltiden genom att låta dig justera gasvolymen i cylindern. Snabb justering av ventilstorleken med inbyggd ställskruv; eliminerar behovet av att byta skruvar för olika ventilstorlekar. Minskar slitage på op-stången, bultlåsningar, mottagare och avtryckargrupp. Finns tillgänglig för M1 Garand och M1A.

SPECS: Stål, parkeriserad yta. Ersätter befintlig gasmutter utan modifikationer på gevär. Inkluderar justeringsverktyg och instruktioner.

Mer...

Kundernas betyg påSCHUSTER M1 ADJUSTABLE GAS SYSTEM

Antal betyg: 6
Från brownells.com: 6
Medelbetyg: 4,8

Work great! (2011-10-24)

Using this to adjust the recoil of the op rod, you really can fine tune your M1A with this plug. Works really well, all you have to do is follow the instructions.

Great product! (2012-09-21)

I ordered this for my new Scout Squad. simple install. Took it to the range, it may take several shots to get it set, (normal), from there you're good to go! Worth the money hands down! Great upgrade in my opinion.

Hard to install Adjust Gas Plug, M1A, (2014-04-24)

I bought this product a couple weeks ago to use on my Spfld Arm. inc. M1A and had trouble screwing it in a Military spec. gas cylinder...at first I thought that it was the wrong thread, but a closer comparison revealed that they were correct, just super tight....I used Krills oil on both threads and turning it a 1/8 of a turn at a time using a 1/2" combo wrench it went home....I took the weapon to the range and ran some Tulammo through it. I had to adjust (tune) the valve per instructions and the M1a operated great...it dropped the cases 2 feet away, kinda just barely making it out of the weapon.....no strain on the op rod at all...it is worth the money if you consider how much an M14 op rod cost to replace....

Great device (2009-09-15)

I really like my adjustable gas plug. It softens up the cycling of my garand and lets me shoots commercial ammo safely. The only downside is that I couldn't screw it in with a 1/4 in. drive socket and had to grind a tool out of an old reciprocating saw blade to install it. Overall it is very good.

Makes the M1-A and M-1 Garand New Rifles (2013-08-02)

I have used the Schuster Adjustable Gas System in both the M1-A and the Garand for several years for general shooting and load developement. It is quite simeple to use. Open the gas adjustment screw to the wide open spot by screwing it out until it is within a turn or two of coming out the front end of the gas valve housing. Shoot a round. Obviously, the rifle is not going to go through its semi-auto functions as the valve is venting all the gas. Open bolt, eject the empty case and lock the action open for safe work at the muzzle! Turn the gas valve adjustment screw inward a couple of turns. Fire a shot. The action may start to work, depending upon the gunpowder you are using and bullet weight. Repeat the process turning the adjustment screw in again. Gently, easy does it! Don't turn too far... As you turn the adjustment screw in and then fire a shot,the bolt may start to come back. Repeat the process of screwing the adjustment screw downward. Fire a shot. This time, the bolt may eject the case and close on an empty chamber. Repeat the process. Now turn the adjustment screw fractions of a complete turn downward. Gently now... The bolt may almost lock open! Repeat the process and this time you may be delighted to find the rifle has performed all the semi-auto functions and is locked open, waiting for the next round. NOW, do not change the setting of the adjusment screw. The rifle should lock open again at the next shot. If it does, you are set FOR THIS POWDER CHARGE AND BULLET COMBINATION. If it does not perform all the functions, turn the adjustment screw downward again and lock it in place with the lock nut the is supplied. Make sure you don't get the allen wrench in so far that as you are adjusting the adjustment screw the same time you are trying to set the lock screw on it! Some fine touch is required for this operation! You will use a little more ammo using this system but you will have a rifle that will operate at minumum impact on itself. Do your chronographing at this point. THEN, REMEMBER TO OPEN THE ADJUSTMENT SCREW ALL THE WAY UP TO START OVER WHEN YOU CHANGE LOADS! Maybe you can figure out a way to reset it to the load you just fired. I have not. I just open it up and start again. I love it!

Must Have (2017-05-18)

Must have part for an m1 if you want to shoot it a lot or don't reload and don't have access to surplus. I'm going to tune mine for modern 180 grain hunting loads, since that's the most common ammo I can get. Better to use new ammo too because it's not corrosive or dirty. If you don't have the tool to change the plugs out, a large flathead screwdriver will work. Set screw is a little tricky to get started, but it works well.

Läs 6 fler betyg på brownells.com

949 1149 2 SEK

Produktnr: 100001733
SCHUSTER M1 ADJUSTABLE GAS SYSTEM
Tillverkarens produktnummer: 10021 Ventilerad ståldesign förändrar cykeltiden genom att låta dig justera gasvolymen i cylindern. Snabb justering av ventilstorleken med inbyggd ställskruv; eliminerar behovet av att byta skruvar för olika ventilstorlekar. Minskar slitage på op-stången, bultlåsningar, mottagare och avtryckargrupp. Finns tillgänglig för M1 Garand och M1A.

949 SEK 0 949,00 kr *

Ej tillgänglig.

Funktioner: Make: Springfield Modell: M1 Garand

Lägg till i inköpslista

Fråga om produkt

Information

Lägg till i inköpslista

Fråga om produkt

Top takeaways

Ventilerad ståldesign som låter dig justera gasvolymen i cylindern för att förändra cykeltiden.
Snabb justering av ventilstorleken med inbyggd ställskruv, vilket eliminerar behovet av att byta skruvar.
Minskar slitage på op-stången, bultlåsningar, mottagare och avtryckargrupp; tillgänglig för M1 Garand och M1A.

Produktinformation

Make: Springfield Modell: M1 Garand Leveransvikt: 0,023kg Leveranshöjd: 5mm Leveransbredd: 79mm Leveranslängd: 130mm

Produkt detaljer

Tillverkas i USA
USA: s exportklassificering: 0A501.x

Ansvarig ekonomisk aktör enligt EU-förordningen

Brownells Sverige AB
Box 99
793 22 Leksand
Sverige
info@brownells.se

Produktnr: 100002329
SCHUSTER M1A ADJUSTABLE GAS SYSTEM
Tillverkarens produktnummer: 10026 Ventilerad ståldesign förändrar cykeltiden genom att låta dig justera gasvolymen i cylindern. Snabb justering av ventilstorleken med inbyggd ställskruv; eliminerar behovet av att byta skruvar för olika ventilstorlekar. Minskar slitage på op-stången, bultlåsningar, mottagare och avtryckargrupp. Finns tillgänglig för M1 Garand och M1A.

1149 SEK 0 1 149,00 kr *

Ej tillgänglig.

Funktioner: Make: Springfield Modell: M14, M1A

Lägg till i inköpslista

Fråga om produkt

Information

Lägg till i inköpslista

Fråga om produkt

Top takeaways

Ventilerad ståldesign som möjliggör justering av gasvolymen i cylindern för att förändra cykeltiden.
Snabb justering av ventilstorleken med inbyggd ställskruv, vilket eliminerar behovet av att byta skruvar.
Minskar slitage på op-stången, bultlåsningar, mottagare och avtryckargrupp; tillgänglig för M1 Garand och M1A.

Produktinformation

Make: Springfield Modell: M14,M1A Leveransvikt: 0,091kg Leveranshöjd: 5mm Leveransbredd: 76mm Leveranslängd: 122mm

Produkt detaljer

Tillverkas i USA
USA: s exportklassificering: 0A501.x

Ansvarig ekonomisk aktör enligt EU-förordningen

Brownells Sverige AB
Box 99
793 22 Leksand
Sverige
info@brownells.se

Upptäck MA Adjustable Gas System för M1 Garand! 🔧 Justera gasvolymen enkelt och minska slitage. Perfekt för din cykelupplevelse!

Saves Wear On Bolt Lugs & Softens Blow On Op Rod

SPECS: Steel, parkerized finish. Replaces existing gas nut with no modifications to the rifle. Includes adjustment tool and instructions.

Mer...

Sparar på slitage av bultlåsningar & dämpar slaget på op-stången

SPECS: Stål, parkeriserad yta. Ersätter befintlig gasmutter utan modifikationer på gevär. Inkluderar justeringsverktyg och instruktioner.

Mer...

Kundernas betyg påSCHUSTER M1 ADJUSTABLE GAS SYSTEM

Antal betyg: 6
Från brownells.com: 6
Medelbetyg: 4,8

Work great! (2011-10-24)

Using this to adjust the recoil of the op rod, you really can fine tune your M1A with this plug. Works really well, all you have to do is follow the instructions.

Great product! (2012-09-21)