Trim the case once—never trim again! The X-Sizer Die looks like a regular Full Length Sizer Die. Inside, the die features a specially designed mandrel with an expander ball and decapping pin attached. The mandrel is what the X-Die® is all about. The patented X-Sizer Die eliminates the need for repeated trimming after an initial trim of .020” off the maximum case length to standardize the case. The X-Die doesn’t shorten the length of the case: the mandrel reduces the growth rate as the case grows as a result of the case mouth-contacting the mandrel during sizing. Because of an extremely close tolerance between the mandrel and die neck wall, the neck wall of the case does not thicken as the case length is pushed back. Cases repeatedly sized in the X-Die will initially grow a few thousandths of an inch, then stabilize below the maximum case length with no discernable loss of accuracy or case life.
Trimma hylsan en gång - trimma aldrig igen! X-Sizer-die ser ut som en vanlig Full Length Sizer Die. Inuti har die en specialdesignad mandrel med en expanderboll och en avtryckspinne fäst. Mandrel är vad X-Die® handlar om. Den patenterade X-Sizer-die eliminerar behovet av upprepade trimningar efter en första trimning av .020” från den maximala hylslängden för att standardisera hylsan. X-Die förkortar inte hylslängden: mandrel minskar tillväxttakten när hylsan växer som ett resultat av att hylsmunnen kommer i kontakt med mandrel under sizing. På grund av en extremt nära tolerans mellan mandrel och die-halsvägg blir inte halsväggen på hylsan tjockare när hylslängden trycks tillbaka. Hylsor som upprepade gånger storleksanpassas i X-Die kommer initialt att växa några tusendelar av en tum, för att sedan stabilisera sig under den maximala hylslängden utan märkbar förlust av noggrannhet eller hylsliv.