The human eye can't detect whether or not a scope reticle is level if the degree is off by 3 degrees or less, but if your scope is off by just 3 degrees, then you're in trouble when it comes to making in-reticle adjustments for those long-range shots. The Fix It Sticks Scope Jack Leveling Tool is designed to get your scope set up right, and it works with any 1/4-inch driver! All you have to do is mount the jack to the Picatinny rail sitting underneath your riflescope. Then turn the drive handle until the arm on the jack engaged with the flat spot underneath your windage and elevation turrets. This ensures that your scope is perfectly level, and the jack will maintain pressure on this flat spot while you tighten your rings down. In order for the Fix It Sticks Scope Jack Leveling Tool to work, you have to have a short section of Picatinny rail sitting just underneath your scope body. Depending on how much clearance is available, you might have to take off the thumb screw and clamp to slide the jack onto the mounting surface from the side. Fix It Sticks says that there must be at least 1/4 inch of clearance to use the jack.
Det mänskliga ögat kan inte upptäcka om ett sikte är i nivå om vinkeln är avvikande med 3 grader eller mindre, men om ditt sikte är avvikande med bara 3 grader, då har du problem när det gäller att göra justeringar i siktet för de långdistansskott. Fix It Sticks Scope Jack Leveling Tool är designad för att hjälpa dig att ställa in ditt sikte korrekt, och den fungerar med vilken 1/4-tums driver som helst! Allt du behöver göra är att montera jacken på Picatinny-skenan som sitter under ditt kikarsikte. Vrid sedan på drivhandtaget tills armen på jacken kopplar ihop med den plana ytan under dina vind- och höjdjusteringar. Detta säkerställer att ditt sikte är perfekt i nivå, och jacken kommer att hålla tryck på denna plana yta medan du spänner dina ringar. För att Fix It Sticks Scope Jack Leveling Tool ska fungera, måste du ha en kort sektion av Picatinny-skena som sitter precis under din siktkropp. Beroende på hur mycket utrymme som finns tillgängligt kan du behöva ta bort tumskruven och klämman för att skjuta jacken på monteringsytan från sidan. Fix It Sticks säger att det måste finnas minst 1/4 tum utrymme för att använda jacken.